AUTONET TV

Flat Tire? Three?s the Charm (Tire Repair)

For most drivers, at some point you’re going to have a flat tire. Depending on how it was damaged, it may have to be replaced.  But sometimes, a repair will do the trick, as long as the puncture isn’t on the sidewall and the hole is smaller than ¼ inch/6.35mm in diameter. Here are the three common ways your tire can be fixed.

One way is to put a plug in the hole.  Since most tires are damaged by running over sharp objects such as screws and nails, the small hole from which the air is escaping is on the part of the tire that touches the road. If it’s in the sidewall, it most likely can’t be fixed.  

In the plug method, a technician inserets a rubber plug.  It is covered with some sticky, gluey stuff, and is pushed into the hole from the outside. That plugs the hole and stays in place, thanks to the glue. Friction from driving heats it up and seals the deal.  

Another method is to patch the hole.  For this, your tire has to first be taken off the vehicle, then off the rim so the technician can get access to the inside. There, they’ll clean the inside surface around the hole and apply a rubber patch with an adhesive on it. This type of patch works well, and because of the extra steps and complexity, costs more than having your tire plugged.  

There’s also a combination of those methods just described, the plug-patch.  It is, in essence, a type of patch with glue on it that has a plug sticking out of it.  The plug is inserted into the tire from the inside and pulled through the hole from the outside, drawing the attached patch tight against the tire’s inside surface. The last two methods can’t be used if the hole is near another repair or the sidewall.    

The good news is if it’s fixed properly, your repaired tire should give you good service.

Joe D'Auria's Auto
1401 BRACE RD
CHERRY HILL, NJ 08034
(56.427.9422
http://www.autorepaircherryhill.com

Straight to the Point (Alignment Signs of Problems)

It’s just common sense that your vehicle will drive better if all the wheels are lined up with each other and the road the way the engineers intended.  When they’re not, that is called being out of alignment.   Here are some signs that your alignment has problems.

• Your steering wheel isn’t straight when your vehicle goes straight down a straight road. This one’s pretty easy to notice.  If your vehicle’s logo on the wheel is tilted, that’s probably not the way designers wanted it to be. Bring it in and have us check it out.
• Your steering wheel is vibrating on a smooth road or when you are accelerating.  While this could be caused by several different things, one possibility is misalignment.  If your steering wheel is shaking, it should be examined by a trained technician.
• Your vehicle is pulling to one side without you wanting it to.  Sometimes the configuration of the road will cause it to pull slightly left or right.  But if you find yourself constantly correcting course to keep your vehicle headed straight down the road, that’s worth having us look at your alignment.
• You’re going through tires like there’s no tomorrow. The tread on your tires should be wearing nice and evenly from the outside to the inside of the tire.  If the wear isn’t even, it could be your vehicle needs an alignment.

We have equipment designed to quickly and accurately measure your vehicle’s alignment.  We can make precise adjustments to make sure you are headed straight where you want to go.  Have your alignment checked regularly. It can help prevent more serious problems in the future and make your vehicle drive as beautifully as you remember it used to.

Joe D'Auria's Auto
1401 BRACE RD
CHERRY HILL, NJ 08034
(56.427.9422
http://www.autorepaircherryhill.com